AUTOCAD LISP ROUTINES FULL
AUTOCAD LISP ROUTINES CODE

dwg file to determine the file version or corresponding AutoCAD version. The file is not commented.ДЄ simple routine which makes it easy to dimension the bearing and distance of a property line by inserting a block with two attributes, then filling the attributes in automatically.ДЄn example of reading the first few characters of a. The data is gathered by entering the room number then picking the corners of the room. This is a little routine that writes a comma-delimited file of room numbers and areas. This is from my 'Sheet Metal Flat Development with AutoCAD' course. This routine uses the k-factor method with the specified k-factor and metal thickness to calculate the developed length of a sheet metal part by selecting the lines and arcs from a cross-section of the part. If invoked transparently the result is returned directly to an AutoCAD command (such as OFFSET). Editable parameters let you put the balloon on a specific layer, adjust the gap between text and balloon and the balloon's lineweight, and specify whether the leader is a block or individual entities.ДЇor sheet-metal fabricators, this routine calculates some common bend-allowance related quantities from specific bend parameters. Both text and balloon continue at the same angle as the last line in the leader. If the text has fewer than 3 characters, the balloon is a DONUT if longer, the balloon is an ELLIPSE. This program creates leaders and encloses the leader text in a 'Balloon'. Note: Using an acad.lsp file runs each time AutoCAD is launched.В An acaddoc.lsp file runs each time a drawing is open.Redefines the FILLET command to allow filleting of non-UCS coplanar lines, and allows radius definition during FILLET. (setq s::startup (append s::startup (quote ((mystartup)))))

AUTOCAD LISP ROUTINES CODE

To ensure compatibility,В appendВ the code in case there is an existing S::STARTUP function. If the S::STARTUP function is defined like this,В problems could arise if other applications use the S::STARTUP function as well (for example, a third-party plug-in). With the same example, the acad.lsp file would look like this:

AUTOCAD LISP ROUTINES FULL

IfВ the AutoLISP routines are not in theВ AutoCAD support paths, include the full path within the acad.lsp file.В Use either '/' or '\' as path delimiters. If wall.lsp and stair.lsp are in the AutoCAD search path, they will automatically load. Create an acad.lsp file that contains the following lines of code and place it in the AutoCAD support paths. If a special function S::STARTUP is defined in theДЇor example, there are two AutoLISP routines named stair.lsp and wall.lsp to be loaded each time AutoCAD is run.

Click Apply and Close to exit the CUI editor.ДЄcad.lsp file is always loaded when AutoCAD starts up.

Browse to the location of the LISP to add and select the file.

Select Load LISP from the context menu.

Select LISP files andВ Right-Mouse Click.

Select the 'acad.cuix' (or a custom partial.

Click Close again to close the Load/Unload Applications dialog.

Once all of the LISP routines have been added to the Startup Suite, click the Close button.

Browse to the location of the LISP file, select it, then click the Open button.

Under Startup Suite, click the Contents button.

To have AutoLISP routines load automatically, either add them to the AutoCAD Startup Suite or use the

Autocad lisp routines